Hyundai Kona: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the luggage side trim. (Refer to Interior Trim - "Luggage Side Trim")

2.	Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar Trim")

After loosening the mounting bolt, then remove the seat belt lower anchor (A).

Tightening torque :

39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

After loosening the mounting bolt, then remove the second row seat belt retractor (A).

Tightening torque :

39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

[LH]

[RH]

To install, reverse removal procedure.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Rear Seat Belt Retractor Components and components location

Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and components location

Component Location 1. Rear center seat belt retractor ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Inhibitor Switch Specifications
Specifications Type: Combination of output signals from 4 terminals Item Specifications Output type Combination of output signals Power supply (V) 12 Signal Code Table ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Limitations of the System
The LKA system may operate prematurely even if the vehicle does not depart from the intended lane, OR, the LKA system may not assist your steering or warn you if the vehicle leaves the intended lane under the following circumstances: When the lane and road conditions are poor It is difficult to ...