Hyundai Kona: Engine Control System / Injector Description and operation

The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.

The ECM controls both the feed circuits (high side) to feed voltage to the injectors and the ground circuits (low side) to energize the injectors. Also, the feed for 2 injectors comes from the same driver set. As the ignition coils are paired with cylinders (1-4 and 2-3), the injectors are also set up in pairs.

Accelerator Position Sensor (APS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the ...

Injector Specifications

Specification Item Specification Coil Resistance (Ω) 1.5 ± 0.075 [20°C (68°F)] ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Vanity mirror lamp
Push the switch to turn the light on or off. : The lamp will turn on if this button is pressed. : The lamp will turn off if this button is pressed. NOTICE Always have the switch in the off position when the vanity mirror lamp is not in use. If the sunvisor is closed without the lamp off, i ...

Hyundai Kona (OS) 2018-2026 Service Manual: TJ Joint Components and components location
Components (1) [Gamma 1.6 T-GDI, Nu 2.0 MPI] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ case ...