Hyundai Kona: Front Bumper / Front Bumper Cover Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Loosen the pin-type retainers and bolts of the front bumper upper.

2.	Loosen the front bumper lower mounting clips.

After loosening the pin-type retainers and screws on the side of front bumper (A), detach the side part of front bumper.

•	When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

4.	Remove the front bumper cover (A).

To install, reverse removal procedure.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Front Bumper Cover Components and components location

Component Location 1. Front bumper cover ...

Radiator Grill Components and components location

Component Location 1. Radiator grill ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal [Tortion Beam Axle Type] 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Power brakes
Your vehicle has power-assisted brakes that adjust automatically through normal usage. If the engine is not running or is turned off while driving, the power assist for the brakes will not work. You can still stop your vehicle by applying greater force to the brake pedal than typical. The stoppin ...