Hyundai Kona: Installing a Child Restraint System (CRS) / Securing a Child Restraint System seat with “Top-tether Anchorage” system
.png)
Top-tether anchorages for Child Restraint Systems are located on the rear of the seatbacks.
.png)
1. Route the Child Restraint System top-tether strap over the seatback. Placing the top tether strap, please follow the instructions of the Child Restraint System manufacturer.
2. Connect the top-tether strap to the top-tether anchorage, then tighten the top-tether strap according to the instructions of your Child Restraint System's manufacturer to firmly attach the Child Restraint System to the seat.
WARNING
Take the following precautions when installing the top-tether:
- Read and follow all installation instructions provided with your Child Restraint System.
- NEVER attach more than one Child Restraint System to a single ISOFIX top-tether anchorage. This could cause the anchorage or attachment to come loose or break.
- Do not attach the top-tether to anything other than the correct top-tether anchorage. It may not work properly if attached to something else.
- Child Restraint System anchorages are designed to withstand only those loads imposed by correctly fitted Child Restraint System.
Under no circumstances are they to be used for adult seat belts or harnesses or for attaching other items or equipment to the vehicle.
Securing a Child Restraint System with the “ISOFIX Anchorage System”
To install an i-Size or ISOFIX-compatible Child Restraint System in either of
the rear outboard seating positions:
1. Move the seat belt buckle away from the ISOFIX anchorages.
2. Move any other obje ...
Suitability of each seating position for ISOFIX Child Restraint Systems according
to ECE regulations
IUF = suitable for ISOFIX forward child restraints systems of universal category
approved for use in the mass group. IL = suitable for particular ISOFIX child
restraints systems (CRS) given in the ...
Other information:
Hyundai Kona (OS) 2018-2019 Service Manual: Auto Light Sensor Repair procedures
Inspection
Check if the auto light control operates like a timing chart shown below.
Tail lamp output and head lamp (Low) output is controlled based on the auto
light sensor's input (illumination intensity) when the Auto Light Switch
in Multi-Function Switch is ...
Hyundai Kona (OS) 2018-2019 Service Manual: Components and components location
Component Location
[Fuel Tank]
1. Fuel tank
2. Fuel pump
3. Fuel filter
4. Fuel pressure regulator
5. Canister
6. Fuel tank air filter
7. Fuel perssure sensor
8. Fuel pump control module (FPCM)
9. Fuel level sender (FLS ...