Hyundai Kona: Front Door / Front Door Side Weatherstrip Repair procedures

Hyundai Kona (OS) 2018-2020 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Side Weatherstrip Repair procedures

Replacement
[Front door side weatherstrip]
1.
Loosen the front door checker (B) mounting bolt.
Tightening torque :
21.6 - 32.4 N.m (2.2 - 3.3 kgf.m,15.9 - 23.9 lb-ft)
2.
Detach the clips, then remove the front door side weatherstrip (A).

3.
To install, reverse removal procedure.
  
Replace any damaged clips (or pin-type retainers).
[Front door body side weatherstrip]
4.
Detach the clips, then remove the front door body side weatherstrip (A).

5.
To install, reverse the removal procedure.
Front Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside ...

Rear Door
...

Other information:

Hyundai Kona (OS) 2018-2020 Service Manual: Components and components location
Components 1. Rear door trim 2. Rear door full handle mounting support 3. Rear door trim seal 4. Rear door hinge 5. Rear door quadrant inner cover 6. Rear door panel 7. Rear door delta molding 8. Rear door belt inside weatherstrip 9. Rear do ...

Hyundai Kona (OS) 2018-2020 Service Manual: Front Impact Sensor (FIS) Description and operation
Description • The front impact sensors (FIS) are installed on the upper of the side panel in Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at their mounting locations. • The pri ...

© 2018-2020 www.hkona.com