Hyundai Kona: Front Seat / Front Seat Cushion Cover Repair procedures

Hyundai Kona (OS) 2018-2025 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Remove the front seat shield inner cover. (Refer to Front Seat - "Front Seat Inner Cover")

3.	Remove the front seat shield outer cover. (Refer to Front Seat - "Front Seat Outer Cover")

4.	Remove the front seat lower protector (A).

5.	Remove the protector (A) from the front seat cushion frame. [Lower] [Upper] [LH] [RH]

6.	Remove the front seat cushion cover (A) from the front seat cushion frame.

7.	After removing the Velcro tape (A) inside the front seat cushion cover, remove the seat cushion cover (B).

8.	To install, reverse removal procedure.

Front Seat Cushion Cover Components and components location

Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly Components and components location

Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

Other information:

Hyundai Kona (OS) 2018-2025 Owners Manual: Emergency tailgate safety release
Your vehicle is equipped with the emergency tailgate safety release lever located on the bottom of the tailgate. When someone is inadvertently locked in the luggage compartment. The tailgate can be opened by doing as follows: 1. Insert the key into the hole. 2. Push the release lever to the right ...

Hyundai Kona (OS) 2018-2025 Service Manual: Passenger Airbag (PAB) Module Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the glove box housing. (Refer to Body - "Glove Box Upper Cover Assembly") 3. ...