Hyundai Kona: Front Seat / Front Seat Shield Inner Cover Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Inner Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Loosen the screws and remove the front seat shield inner cover (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Front Seat Shield Inner Cover Components and components location

Component Location 1. Front seat shield inner cover ...

Front Seat Back Cover Components and components location

Component Location 1. Front seat back cover ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Special service tools
Special Service Tools Tool (Number and Name) IIIustration Use 09568-1S100 Ball joint remover Ball joint remover ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Operating conditions
To operate: Press the BCW switch with the Ignition switch in the ON position. The indicator on the BCW switch will illuminate. When the vehicle speed exceeds 30 km/h (20 mph), the system will be activated. To cancel: Press the BCW switch again. The indicator on the switch will go off. When the sys ...