Hyundai Kona: ABS (Anti-Lock Brake System) / Front Wheel Speed Sensor Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Brake System / ABS (Anti-Lock Brake System) / Front Wheel Speed Sensor Repair procedures

Removal

1.	Turn the ignition switch OFF and then disconnect the negative (-) battery cable.

2.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the front wheel and tire (A) from front hub.

Tightening torque :

107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

•	Be careful not to damage the hub bolts when removing the front wheel and tire (A).

4.	Remove the front wheel guard. (Refer to Body - "Front Wheel Guard")

5.	Disconnect the wheel speed sensor connector (A) and then remove the fixing clip (B).

Remove the front wheel speed sensor cable braket bolt (A), (B).

Tightening torque :

6.8 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 7.9 lb-ft)

Loosen the bolt (A) and then remove the front wheel speed sensor.

Tightening torque :

7.8 - 11.7 N.m (0.7 - 1.1 kgf.m, 5.7 - 8.6 lb-ft)

Installation

1.	To install, reverse the removal procedure.

Inspection

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

•	In order to protect the wheel speed sensor, when measuring output voltage, a 100Ω resister must be used as shown.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V - 0.84V

V_high : 1.18V - 1.68V

Frequency range : 1 - 2,500 Hz

Front Wheel Speed Sensor Components and components location

Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

Rear Wheel Speed Sensor Components and components location

Components [Tortion beam axle type] 1. Front wheel speed sensor 2. Rear wheel speed sensor cable [Multi link type] ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Climate control air filter
This filter is installed behind the glove box. It filters the dust or other pollutants that enter the vehicle through the heating and air conditioning system. We recommend that the climate control air filter be replaced by an authorized HYUNDAI dealer according to the maintenance schedule. If the ...

Hyundai Kona (OS) 2018-2026 Service Manual: Accelerator Position Sensor (APS) Description and operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual ...