Hyundai Kona: Fuel Delivery System / Fuel Pressure Regulator Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Regulator Repair procedures

Removal

1.	Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump")

2.	Disconnect the fuel pump motor connector (A), and the fuel sender connector (B).

3.	Press the fixing hook (A) with a driver and then remove fuel sender (B) in the arrow direction.

4.	Remove the fuel feed tube (B) after removing the fix clip (A).

5.	Remove the head assembly (D) after removing the fix hooks (C).

6.	Remove the reservior-cup (B) after releasing the fixing hooks (A).

7.	Disconnect the ground cable (A).

8.	Disconnect the fuel pump motor connector (B).

9.	Remove the snap pin (A), and then remove the fuel pressure regulator (B).

Installation

1.	Install in the reverse order of removal.

Fuel Sender Repair procedures

Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the fuel sender connector ( ...

Fuel Pump Control Module (FPCM) Description and operation

Description The fuel pump control module (FPCM) is installed on the right side of the fuel tank and controls the DC motor mounted inside the low pressure fuel pump.The module com ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Repair procedures
Inspection ESP System Bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid. ...

Hyundai Kona (OS) 2018-2026 Service Manual: Thermostat Components and components location
Components 1. Water inlet fitting 2. Thermostat ...