Hyundai Kona: Lighting System / Hazard Lamp Switch Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Repair procedures

Inspection

1.	Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.

Removal

•	Wrap the protective tape on the tool to disassemble with the screwdriver or remover.

•	e caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.

•	Use caution for the crash pad garnish and door trim upper garnish made of timber (Real wood) because they can be scratched or picked.

•	Be careful not to scratch the door trim and other parts.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad garnish RH assembly. (Refer to Body - "Crash Pad Garnish")

3.	Disconnect the connectors (A).

Installation

1.	Install the hazard lamp switch

2.	Install the crash pad garnish RH assembly.

3.	Connect the negative (-) battery terminal.

Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace ...

Rheostat Components and components location

Components ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Hub - Carrier Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 107.9 - 127.5 N. ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Emergency tailgate safety release
Your vehicle is equipped with the emergency tailgate safety release lever located on the bottom of the tailgate. When someone is inadvertently locked in the luggage compartment. The tailgate can be opened by doing as follows: 1. Insert the key into the hole. 2. Push the release lever to the right ...