Hyundai Kona: Electronic Stability Control (ESC) / Indicator lights
.png)
When the ignition switch is in the ON position, the ESC indicator light illuminates, then goes off if the ESC system is operating normally.
The ESC indicator light blinks whenever the ESC is operating.
If the ESC indicator light stays on, your vehicle may have a malfunction with the ESC system. When this warning light illuminates we recommend that the vehicle be checked by an authorized HYUNDAI dealer as soon as possible.
The ESC OFF indicator light comes on when the ESC is turned off with the button.
WARNING
When the ESC is blinking, this indicates the ESC is active:
Drive slowly and NEVER attempt to accelerate. NEVER turn the ESC off while the ESC indicator light is blinking or you may lose control of the vehicle resulting in an accident.
NOTICE
Driving with wheels and tires with different sizes may cause the ESC system to malfunction. Before replacing tires, make sure all four tires and wheels are the same size. Never drive the vehicle with different sized wheels and tires installed.
ESC operation
ESC ON condition
When the ignition switch is in the ON position, the ESC and the ESC OFF indicator
lights illuminate for approximately three seconds and goes off, then the ESC is
turned on.
When ope ...
ESC OFF usage
When Driving
The ESC OFF mode should only be used briefly to help free the vehicle if stuck
in snow or mud, by temporarily stopping operation of the ESC, to maintain wheel
torque.
To turn ESC off wh ...
Other information:
Hyundai Kona (OS) 2018-2026 Owners Manual: Auto defogging system (only for automatic climate control system, if equipped)
Auto defogging reduces the possibility of fogging up the inside of the windshield
by automatically sensing the moisture on inside the windshield.
The auto defogging system operates when the heater or air conditioning is on.
Information
The auto defogging system may not operate normally, when the ou ...
Hyundai Kona (OS) 2018-2026 Service Manual: Rear Door Outside Handle Repair procedures
Replacement
1.
Remove the plug hole.
2.
After loosening the mounting bolt, remove the rear door outside handle
cover (A).
Tightening torque :
7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)
...
