Hyundai Kona: Dual Clutch Transmission Control System / Input shaft speed sensor 1 Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 1 Repair procedures

Removal

1.	Remove the cleaner assembly and air duct. (Refer to Engine Mechainical System - "Air Cleaner")

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Remove the ECM. (Refer to Engine Cotrol System - "ECM")

4.	Disconnect the Input shaft speed sensor connector (A).

5.	Remove the clutch actuator. (Refer to Dual Clutch Transmission Control System - "Clutch Actuator Assembly").

Remove the Input shaft speed sensor (A).

Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2kgf.m, 7.2 - 8.7 lb-ft)

Installation

To install, reverse the removal procedure.

•	Before installing the input speed sensor, check the assembled state of the O-rings (A) and should apply gear oil to the surface of O-rings.

Input shaft speed sensor 1 Schematic diagrams

Circuit Diagram ...

Input shaft speed sensor 2 Components and components location

Components 1. Input shaft speed sensor 1 (Odd) 2. Input shaft speed sensor 2 (Even) ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Seat Cushion Cover Repair procedures
Replacement • Put on gloves to prevent hand injuries. • Wh ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Automatic heating and air conditioning
The Automatic Climate Control System is controlled by setting the desired temperature. 1. Press the AUTO button. (3) The modes, fan speeds, air intake and air-conditioning will be controlled automatically by the temperature setting you select. 2. Turn the temperature control knob (1) to the desired ...