Hyundai Kona: Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the MAPS at idle and IG ON.

Specification : Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.

Manifold absolute pressure sensor installation bolt :

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Manifold Absolute Pressure Sensor (MAPS) Schematic diagrams

Circuit Diagram Harness Connector ...

Intake Air Temperature Sensor (IATS) Description and operation

Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Starting the engine
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes, such as high heels, ski boots, sandals, flip-flops, etc., may interfere with your ability to use the brake, accelerator and clutch pedals. Do not start the vehicle with the accelerator pedal depressed. The ...

Hyundai Kona (OS) 2018-2026 Service Manual: Components and components location
Components NO Connector A Connector B Connector C Connector D 1 Batt (+) Front wiper switch P CAN (low) ...