Hyundai Kona: Front seats / Manual adjustment

Forward and rearward adjustment

To move the seat forward or rearward:

1. Pull up the seat slide adjustment lever and hold it.

2. Slide the seat to the position you desire.

3. Release the lever and make sure the seat is locked in place. Move forward and rearward without using the lever. If the seat moves, it is not locked properly.

Seatback angle

To recline the seatback:

1. Lean forward slightly and lift up the seatback lever.

2. Carefully lean back on the seat and adjust the seatback to the position you desire.

3. Release the knob and make sure the seatback is locked in place.

Reclining seatback

Sitting in a reclined position when the vehicle is in motion can be dangerous. Even when buckled up, the protections of your restraint system (seat belts and/or air bags) is greatly reduced by reclining your seatback.

WARNING

NEVER ride with a reclined seatback when the vehicle is moving. Riding with a reclined seatback increases your chance of serious or fatal injuries in the event of a collision or sudden stop.

Drivers and passengers should ALWAYS sit well back in their seats, properly belted, and with the seatbacks upright.

Seat belts must be snug against your hips and chest to work properly. When the seatback is reclined, the shoulder belt cannot do its job because it will not be snug against your chest. Instead, it will be in front of you. During an accident, you could be thrown into the seat belt, causing neck or other injuries.

The more the seatback is reclined, the greater chance the passenger’s hips will slide under the lap belt or the passenger’s neck will strike the shoulder belt.

Seat cushion height

To change the height of the seat cushion:

Front seats
The front seat can be adjusted by using the control lever (or knob) or switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can eas ...

Power adjustment
WARNING NEVER allow children in the vehicle unattended. The power seats are operable when the engine is turned off. NOTICE To prevent damage to the seats: Always stop adjusting the seats when the s ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Input shaft speed sensor 1 Description and operation
Description • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Contr ...

Hyundai Kona (OS) 2018-2024 Service Manual: Crash Pad Side Cover Components and components location
Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

© 2018-2024 www.hkona.com