Hyundai Kona: Windshield defrosting and defogging / Manual climate control system
To defog inside windshield
.png)
1. Select any fan speed except “0” position.
2. Select the desired temperature.
3. Select the .png)
or
.png)
position.
4. The outside (fresh) air will be selected automatically. Additionally, the
air conditioning (if equipped) will automatically operate if the mode is selected
to the position.
If the air conditioning and outside (fresh) air position are not selected automatically, press the corresponding button manually.
To defrost outside windshield
.png)
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot position.
3. Select the position.
4. The outside (fresh) air and air conditioning (if equipped) will be selected automatically.
Windshield defrosting and defogging
WARNING
Windshield heating Do not use the
or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and that of the windshield co ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: A/C Pressure Transducer Description and operation
Description
The A/C Pressure Transducer (APT) converts the pressure value of high pressure
line into voltage value after measuring it. By converted voltage value,
engine ECU controls the cooling fan by operating it high speed or low speed.
Engine ECU stops the opera ...
Hyundai Kona (OS) 2018-2026 Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T.
and W.O.T.
Specification : Refer t ...
