Hyundai Kona: Lubrication System / Oil Cooler Repair procedures

Removal

1.	Loosen the drain plug and drain the coolant. Open the radiator cap to make rapid draining. (Refer to Cooling System - "Coolant")

2.	Disconnect the oil cooler hoses (A).

3.	Remove the oil filter (A) with the SST (09263-2E000, the oil filter wrench).

Loosen the mounting bolt (A), and then remove the oil cooler assembly (B).

Tightening torque :

50.0 - 55.8 N.m (5.1 - 5.7 kgf.m, 36.8 - 41.2 lb-ft)

Installation

Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler (C) with fix bolt (B).

Tightening torque :

50.0 - 55.8 N.m (5.1 - 5.7 kgf.m, 36.8 - 41.2 lb-ft)

Install the oil filter (A) with the SST (09263-2E000, the oil filter wrench).

Tightening torque :

11.7 - 15.6 N.m (1.2 - 1.6 kgf.m, 8.6 - 11.5 lb-ft)

3.	Install the oil cooler hoses (A).

4.	Fill the radiator with coolant and check for leaks. (Refer to Cooling System - "Coolant")

Removal and Installation 1. Remove the oil lever gauge and pipe (A). Tightening torque : 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - ...

...

Hyundai Kona (OS) 2018-2024 Service Manual: Fuel Pressure Sensor (FPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 50 (0. ...

Hyundai Kona (OS) 2018-2024 Service Manual: Rear Coil Spring Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from front hub. Tightening torque : 107.9 - 127.5 N ...