Hyundai Kona: Lubrication System / Oil Level Gauge & Pipe Repair procedures

Removal and Installation
1.
Remove the oil lever gauge and pipe (A).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

2.
Install in the reverse order of removal.
Oil Pan Repair procedures
Removal 1. Remove the under cover. (Refer to Engine and Transaxle Assembly - "Engine Under Cover") 2. Drain engine oil. ...

Oil Cooler Repair procedures
Removal 1. Loosen the drain plug and drain the coolant. Open the radiator cap to make rapid draining. (Refer to Cooling System - "Coolant") ...

Other information:

Hyundai Kona (OS) 2018-2021 Service Manual: Intake Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V t ...

Hyundai Kona (OS) 2018-2021 Service Manual: Crankshaft Position Sensor (CKPS) Description and operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed in ladder fram ...

© 2018-2021 www.hkona.com