Hyundai Kona: Fuel Delivery System / Fuel Pressure Sensor (FPS) Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.	Check the output voltage of fuel pressure sensor (FPS).

Pressure [kPa (kgf/cm², psi)]	Output Voltage (V)
50 (0.51, 7.3)	0.3
600 (6.12, 87.0)	2.5
1100 (11.2, 159.5)	4.5

Removal

1.	Turn the ignition switch OFF, and then remove battery (-) terminal.

2.	Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly")

3.	Remove the fuel pump service cover (A).

4.	Disconnect the fuel pressure sensor connector (A).

5.	Remove the fuel pressure sensor fixing pin (B).

6.	Remove the fuel pressure sensor from the fuel pump.

Installation

1.	Install in the reverse order of removal.

Fuel Pressure Sensor (FPS) Schematic diagrams

Circuit Diagram Terminal Illustration Terminal Function No Function Connected to 1 F ...

Fuel Line Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Cruise Control Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel assembly. (Refer to Steering System - "Steering Wheel") 3. Remove the screws from the steering back cover ...

Hyundai Kona (OS) 2018-2026 Service Manual: Starter Description and operation
Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current f ...