Hyundai Kona: Mirror / Outside Rear View Mirror Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Mirror / Outside Rear View Mirror Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Using a screwdriver or remover, remove the front door quadrant inner cover (A).

2.	Disconnect the outside rear view mirror connector (A).

After loosening the mounting nuts, remove the outside rear view mirror (A).

Tightening torque :

6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)

•	When removing the nut (B), be sure to remove it using a spanner.

•	Remove the mirror assembly with pressing the upper and lower flanges (C) of temporary fixing clip.

To install, reverse removal procedure.

•	Make sure the connector is connected properly.

•	Replace any damaged clips (or pin-type retainers).

Outside Rear View Mirror Components and components location

Component Location 1. Outside rear view mirror ...

Inside Rear View Mirror Components and components location

Component Location 1. Inside rear view mirror ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Snow or icy conditions
You need to keep sufficient distance between your vehicle and the vehicle in front of you. Apply the brakes gently. Speeding, rapid acceleration, sudden brake applications, and sharp turns are potentially very hazardous practices. During deceleration, use engine braking to the fullest extent. Sud ...

Hyundai Kona (OS) 2018-2026 Service Manual: Liftgate Assembly Repair procedures
Replacement • Wear gloves to protect hands from injury. • ...