Hyundai Kona: Power Door Locks / Power Door Lock Switch Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch Repair procedures

Inspection

Power Door Lock Switch Inspection

1.	Check for continuity between the terminals. If there is an abnormality, replace the switch.

Removal

•	Be careful not to scratch the door trim and other parts.

•	Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.

Driver Power Window Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Remove the power window switch assembly (A) after disengaging the mounting clips.

Installation

1.	Install the power window switch assembly.

2.	Install the front door trim after connect the connector.

3.	Connect the negative (-) battery terminal.

Power Door Lock Module Repair procedures

Inspection • Wrap the protective tape on the tool to disassembl ...

Power Door Mirrors

...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Front Strut Assembly Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightening torque : 107.9 - 12 ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Four wheel drive (4WD)
The Four Wheel Drive (4WD) System delivers engine power to all front and rear wheels for maximum traction. 4WD is useful when extra traction is required on roads such slippery, muddy, wet, or snow-covered roads. Occasional off-road use such as established unpaved roads and trails are OK. It is a ...