Hyundai Kona: Rear Seat / Rear Seat Cushion Cover Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
After removing the Velcro tape (A) and hog-ring clips (B) inside the rear seat cushion cover, remove the seat cushion cover (C).
[Front side]

[Rear side]

3.
To install, reverse removal procedure.
  
•
Make sure that the connectors are connected completely.
•
Replace any damaged clips (or pin-type retainers).
•
To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880 - 4F000).

Rear Seat Cushion Cover Components and components location
Component Location 1. Rear seat cushion cover ...

Rear Seat Latch Components and components location
Components Location 1. Reat seat latch [LH] 2. Reat seat latch [RH] ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Putting in a flat tool (Ø5mm) into the guide hole (A) and then release the DAB fixed pin. ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Battery recharging
By battery charger Your vehicle has a maintenance-free, calcium-based battery. If the battery becomes discharged in a short time (because, for example, the headlights or interior lights were left on while the vehicle was not in use), recharge it by slow charging (trickle) for 10 hours. If the ...

© 2018-2026 www.hkona.com