Hyundai Kona: Horn / Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Horn / Repair procedures

Removal

1.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

2.	Remove the horn (A) after loosening the mounting the bolt.

Installation

1.	Install the horns after connect the horn connectors.

2.	Install the front bumper cover.

Inspection

1.	In this vehicle, the horn relay is mounted in the PCB block of the engine compartment relay block.

•	The semiconductor relay inserted in the PCB cannot be replaced.

•	If you need to replace the relay, replace the PCB block and perform the test.

Components and components location

Component Location 1. Horn switch 2. Horn relay (Built - in PCB Block) 3. Horn 4. Clock spring ...

Audio

...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Description and operation
Description This specification applies to HCU (Hydraulic Control Unit) and ECU (Electronic Control Unit) of the HECU (Hydraulic and Electronic Control Unit). This specification is for the wiring design and installation of ABS ECU. This unit has the functions as follows. ...

Hyundai Kona (OS) 2018-2026 Service Manual: Propeller Shaft Repair procedures
Removal 1. After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A). Tightening torque : 49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.1 - 47.0 lb-ft) ...