Removal |
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
|
2. |
Disconnect the fuel pump motor connector (A), and the fuel sender connector
(B).
|
3. |
Press the fixing hook (A) with a driver and then remove fuel sender
(B) in the arrow direction.
|
4. |
Remove the fuel feed tube (B) after removing the fix clip (A).
|
5. |
Remove the head assembly (D) after removing the fix hooks (C).
|
6. |
Remove the reservior-cup (B) after releasing the fixing hooks (A).
|
7. |
Disconnect the ground cable (A).
|
8. |
Disconnect the fuel pump motor connector (B).
|
9. |
Remove the snap pin (A), and then remove the fuel pressure regulator
(B).
|
10. |
Remove the pre-filter (B) after releasing the fixing hooks (A).
|
11. |
Remove the fuel pump motor (B) in the arrow direction.
|
12. |
Remove the fuel filter bracket (A) after releasing the fixing hooks.
|
13. |
Remove the fuel filter.
|
Installation |
1. |
Install in the reverse order of removal.
|
Hyundai Kona (OS) 2018-2023 Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification : Refe ...
Hyundai Kona (OS) 2018-2023 Service Manual: Special service tools
Special Service Tools
Tool
(Number and Name)
Illustration
Use
09200-3N000
Engine support fixture
(Beam)
Removal and installation of the transaxle.
Use this beam (SST No. : 09200-3N000) with ...