| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bubper.
(Refer to Body - "Rear Bumper")
|
| 3. |
Loosen the screw and then remove the rear fog lamp assembly. [Left
side only]
|
| 4. |
Remove the back up lamp bulb. [Light side only]
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bubper.
(Refer to Body - "Rear Bumper")
|
| 3. |
Loosen the screw and then remove the rear fog lamp assembly. [Right
side only]
|
| 4. |
Remove the back up lamp bulb. [Right side lamp only]
|
Front Fog Lamps Repair procedures
License Lamps Repair proceduresHyundai Kona (OS) 2018-2026 Owners Manual: 4 Wheel Drive (4WD) LOCK Indicator Light
This indicator light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON
position. - It illuminates for approximately 3 seconds and then goes off.
When you select 4WD Lock mode by pressing the 4WD LOCK button. - The
4WD LOCK mode is to increase the drive power ...
Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies greatly upward or downward
"Surging" (repeated alternating accelerati ...