Hyundai Kona: ISG (Idle Stop & Go) System / Seat Belt Switch Repair procedures

Inspection
1.
Remove the connector from the switch.
2.
Check for continuity between terminals.
Seat belt condition
Continuity
Fastened
Non-conductive (∞Ω)
Not fastened
Conductive (Ω)

Removal
1.
Remove the front seat.
2.
After loosening the mounting bolt, then remove the front seat belt buckle (A).

Installation
1.
Install in the reverse of removal.
Seat Belt Switch Description and operation
Description Via the seat belt/Door switch, the ISG function can detect that the driver has fastened the seat belt/door. If the driver has not fastened the seat belt/door, the ISG ...

Hood Switch Description and operation
Description The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or stopped by the I ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Windshield wipers
Operates as follows when the ignition switch is turned ON. /MIST : For a single wiping cycle, move the lever down ( ) or up (MIST) and release it. The wipers will operate continuously if the lever is held in this position. O/OFF : Wiper is not in operation ---/INT : Wiper operates intermittently a ...

Hyundai Kona (OS) 2018-2026 Service Manual: DC/DC Converter Repair procedures
Removal [200W] 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disc ...

© 2018-2026 www.hkona.com