Hyundai Kona: Airbag Module / Side Airbag (SAB) Module Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module Repair procedures

Removal
  
•
The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
Remove the seat back cover.
(Refer to Body - "Front Seat Back Cover")
4.
Remove the side airbag (A) after loosening the side airbag mounting nuts.

Installation
  
•
Be sure to install the harness wires so they will not pinch or interfere with other parts.
  
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
4.
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly")
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation :
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Side Airbag (SAB) Module Description and operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment o ...

Curtain Airbag (CAB) Module Components and components location
Components 1. Curtain Air Bag (CAB) ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: For safe 4WD operation
Before driving Make sure all passengers are wearing seat belts. Sit upright and closer to the steering wheel than usual. Adjust the steering wheel to a position comfortable for you to drive. Driving on snow-covered or icy roads Start off slowly by applying the accelerator pedal gently. Use ...

Hyundai Kona (OS) 2018-2026 Owners Manual: 4 Wheel Drive (4WD) LOCK Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select 4WD Lock mode by pressing the 4WD LOCK button. - The 4WD LOCK mode is to increase the drive power ...

© 2018-2026 www.hkona.com