Hyundai Kona: System setting and activation / System setting

• The driver can activate the FCA by placing the ignition switch to the ON position and by selecting:

"User Settings Driver assistance Forward Collision-avoidance Assist (FCA)"

The FCA deactivates, when the driver cancels the system setting.

The warning light illuminates on the LCD display, when you cancel the FCA system. The driver can monitor the FCA ON/OFF status on the LCD display. Also, the warning light illuminates when the ESC (Electronic Stability Control) is turned off. If the warning light remains ON when the FCA is activated, we recommend that you have the system checked by an authorized HYUNDAI dealer.

• The driver can select the initial warning activation time on the LCD display.

Go to the "User Settings Driver assistance Forward Collision Warning Late/Normal/Early".

The options for the initial Forward Collision Warning includes the following:

- Early:

When this condition is selected, the initial Forward Collision Warning is activated earlier than normal. This setting maximizes the amount of distance between the vehicle or pedestrian ahead before the initial warning occurs.

Even though, 'Early' is selected if the front vehicle suddenly stops the initial warning activation time may not seem fast.

If you feel the warning activates too early, set the Forward Collision Warning to "Normal".

- Normal:

When this condition is selected, the initial Forward Collision Warning is activated normally. This setting allows for a nominal amount of distance between the vehicle or pedestrian ahead before the initial warning occurs.

- Late:

When this condition is selected, the initial Forward Collision Warning is activated later than normal. This setting reduces the amount of distance between the vehicle or pedestrian ahead before the initial warning occurs.

Select 'Late' when traffic is light and when driving speed is slow.

System setting and activation
...

Prerequisite for activation
The FCA gets ready to be activated, when the FCA is selected on the LCD display, and when the following prerequisites are satisfied. - The ESC (Electronic Stability Control) is on. - Vehicle speed is ...

Other information:

Hyundai Kona (OS) 2018-2019 Service Manual: Room Lamp Repair procedures
Removal [Room Lamp] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp. &n ...

Hyundai Kona (OS) 2018-2019 Owners Manual: Vehicle identification number (VIN)
The vehicle identification number (VIN) is the number used in registering your vehicle and in all legal matters pertaining to its ownership, etc. The number is punched on the floor under the right front seat. To check the number, open the cover. The VIN is also on a plate attached to the top of ...

© 2018-2019 www.hkona.com