| Troubleshooting |
| Problem Symptoms Table |
|
Symptom |
Suspected Area |
|
No blower operation |
1. Blower fuse |
|
2. Blower relay |
|
|
3. Blower motor |
|
|
4. Power mosfet |
|
|
5. Blower speed control switch |
|
|
6. Wire harness |
|
|
No air temperature control |
1. Engine coolant capacity |
|
2. Heater control assembly |
|
|
No compressor operation |
1. Refrigerant capacity |
|
2. A/C fuse |
|
|
3. Compressor |
|
|
4. A/C pressure transducer |
|
|
5. A/C switch |
|
|
6. Evaporator temperature sensor |
|
|
7. Wire harness |
|
|
Vented air not cold |
1. Refrigerant capacity |
|
2. Refrigerant pressure |
|
|
3. Drive belt |
|
|
4. Compressor |
|
|
5. A/C pressure transducer |
|
|
6. Evaporator temperature sensor |
|
|
7. A/C switch |
|
|
8. Heater control assembly |
|
|
9. Wire harness |
|
|
Insufficient cooling |
1. Refrigerant capacity |
|
2. Drive belt |
|
|
3. Compressor |
|
|
4. Condenser |
|
|
5. Expansion valve |
|
|
6. Evaporator |
|
|
7. Refrigerant lines |
|
|
8. A/C pressure transducer |
|
|
9. Heater control assembly |
|
|
No engine idle-up when A/C switch ON |
1. Engine ECM |
|
2. Wire harness |
|
|
No air inlet control |
1. Heater control assembly |
|
No mode control |
1. Heater control assembly |
|
2. Mode actuator |
|
|
No cooling fan operation |
1. Cooling fan fuse |
|
2. Fan motor |
|
|
3. Engine ECM |
|
|
4. Wire harness |
Specifications
Special service toolsHyundai Kona (OS) 2018-2026 Service Manual: Rear Pillar Trim Repair procedures
Replacement
•
Put on gloves to prevent hand injuries.
•
Wh ...
Hyundai Kona (OS) 2018-2026 Owners Manual: Auto up/down window
Auto down window
Pressing the power window switch momentarily to the second detent position (6)
completely lowers the window even when the switch is released. To stop the window
at the desired position while the window is in operation, pull up or press down
and release the switch.
Auto up/down wi ...