Hyundai Kona: Cruise Control operation / To set Cruise Control speed
.png)
1. Press the .png)
(CRUISE) button on the
steering wheel to turn the system on. The
(CRUISE) indicator will illuminate.
2. Accelerate to the desired speed, which must be more than 30 km/h (20 mph).
Information - Manual transmission
For manual transmission vehicles, you should depress the brake pedal at least once to set the cruise control after starting the engine.
.png)
3. Push the toggle switch down (SET-), and release it. The SET indicator light will illuminate.
4. Release the accelerator pedal.
Information
On a steep slope, the vehicle may slightly slow down or speed up, while driving uphill or downhill.
Cruise Control operation
1. CRUISE () indicator
2. SET indicator
The Cruise Control system allows you to drive at speeds above 30 km/h (20 mph)
without depressing the accelerator pedal.
WARNING
Take the following precaution ...
To increase Cruise Control speed
Push the toggle switch up (RES+) and hold it, while monitoring the SET
speed on the instrument cluster. Release the toggle switch when the desired
speed is shown and the vehicle will accelerate ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Front Driveshaft Repair procedures
Removal
[Gamma 1.6 T-GDI, Nu 2.0 MPI]
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the front hub.
Tightenin ...
Hyundai Kona (OS) 2018-2026 Service Manual: TPMS Receiver Description and operation
Description
TPMS Receiver : BCM(body control module) integrated management
1.
Mode
(1)
Virgin State
•
The receiver as a sole part is shipped in this state.
Replacem ...
