Hyundai Kona: Cruise control / Cruise Control operation
.png)
1. CRUISE (.png)
) indicator
2. SET indicator
The Cruise Control system allows you to drive at speeds above 30 km/h (20 mph) without depressing the accelerator pedal.
WARNING
Take the following precautions:
- Always set the vehicle speed under the speed limit in your country.
- If the Cruise Control is left on, (CRUISE ()
indicator light in the instrument cluster is illuminated) the Cruise Control
can be activated unintentionally. Keep the Cruise Control system off (CRUISE
indicator light OFF) when the Cruise Control is not in use, to avoid inadvertently
setting a speed.
- Use the Cruise Control system only when traveling on open highways in good weather.
- Do not use the Cruise Control when it may be unsafe to keep the vehicle
at a constant speed:
- When driving in heavy traffic or when traffic conditions make it difficult to drive at a constant speed
- When driving on rainy, icy, or snow-covered roads
- When driving on hilly or windy roads
- When driving in windy areas - Do not use cruise control when towing a trailer.
NOTICE
During cruise-speed driving of a manual transmission vehicle, do not shift into neutral without depressing the clutch pedal, since the engine will be overrevved. If this happens, depress the clutch pedal or press the cruise control ON / OFF button.
Information
- During normal cruise control operation, when the SET switch is activated or reactivated after applying the brakes, the cruise control will activate after approximately 3 seconds. This delay is normal.
- Before activating the cruise control function, the system will check to verify that the brake switch is operating normally. Depress the brake pedal at least once after turning ON the ignition or starting the vehicle.
Cruise control switch
.png)
O (Cancel): Cancels cruise control operation.
CRUISE (,.png)
):
Turns cruise control system on or off.
RES+: Resumes or increases cruise control speed.
SET-: Sets or decreases cruise control speed.
Information
.png)
First, switch the mode to Cruise Control by pressing the
button if equipped with the Speed Limit
Control System.
The mode changes, as below, whenever the
button is pressed.
.png)
- To set Cruise Control speed
- To increase Cruise Control speed
- To decrease Cruise Control speed
- To temporarily accelerate with the Cruise Control ON
- Cruise Control will be canceled when:
- To resume preset Cruising speed
- To turn Cruise Control off
Cruise control
...
To set Cruise Control speed
1. Press the (CRUISE) button on the
steering wheel to turn the system on. The
(CRUISE) indicator will illuminate.
2. Accelerate to the desired speed, which must be more than 30 km/h (20 mph).
Inform ...
Other information:
Hyundai Kona (OS) 2018-2020 Owners Manual: Additional safety precautions
Passengers should not move out of or change seats while the vehicle is moving.
A passenger who is not wearing a seat belt during a crash or emergency stop can
be thrown against the inside of the vehicle, against other occupants, or be ejected
from the vehicle.
Do not use any accessories on seat b ...
Hyundai Kona (OS) 2018-2020 Service Manual: A/C Pressure Transducer Description and operation
Description
The A/C Pressure Transducer (APT) converts the pressure value of high pressure
line into voltage value after measuring it. By converted voltage value,
engine ECU controls the cooling fan by operating it high speed or low speed.
Engine ECU stops the opera ...