Hyundai Kona: Cruise Control operation / Cruise Control will be canceled when:
.png)
- Depressing the brake pedal.
- Depressing the clutch pedal. (for manual transmission vehicle)
- Pressing the O (Cancel) button located on the steering wheel.
- Pressing the
.png)
(CRUISE) button.
Both the (CRUISE) indicator and
the SET indicator will turn OFF. - Pressing the
.png)
button. Both
the (CRUISE) indicator and the SET
indicator will turn OFF. (if equipped with the Speed Limit Control) - Moving the shift lever into N (Neutral). (for dual clutch transmission vehicle)
- Decreasing the vehicle speed to less than approximately 30 km/h (20 mph).
- The ESC (Electronic Stability Control) is operating.
- Downshifting to the 2nd gear in manual shift mode. (for dual clutch transmission vehicle)
Information
Each of the above actions will cancel Cruise Control operation (the SET indicator
light in the instrument cluster will go off), but only pressing the
(CRUISE) button will turn the system
off. If you wish to resume Cruise Control operation, push the toggle switch up (RES+)
located on your steering wheel. You will return to your previously preset speed,
unless the system was turned off using the
(CRUISE) button.
To temporarily accelerate with the Cruise Control ON
Depress the accelerator pedal.When you take your foot off the accelerator, the
vehicle will return to the previously set speed.
If you push the toggle switch down (SET-) at the increased speed, the C ...
To resume preset Cruising speed
Push the toggle switch up (RES+). If the vehicle speed is over 30 km/h (20 mph),
the vehicle will resume the preset speed. ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Fender Garnish Repair procedures
Replacement
•
Put on gloves to prevent hand injuries.
•
Wh ...
Hyundai Kona (OS) 2018-2026 Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal
[Tortion Beam Axle Type]
1.
Turn the ignition switch OFF and then disconnect the negative (-) battery
cable.
2.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
...
