Hyundai Kona: Disc brakes wear indicator / Vehicle Stability Management
The Vehicle Stability Management (VSM) is a function of the Electronic Stability Control (ESC) system. It helps ensure the vehicle stays stable when accelerating or braking suddenly on wet, slippery and rough roads where traction over the four tires can suddenly become uneven.
WARNING
Take the following precautions when using the Vehicle Stability Management (VSM):
- ALWAYS check the speed and the distance to the vehicle ahead. The VSM is not a substitute for safe driving practices.
- Never drive too fast for the road conditions. The VSM system will not prevent accidents. Excessive speed in bad weather, slippery and uneven roads can result in severe accidents.
ESC OFF usage
When Driving
The ESC OFF mode should only be used briefly to help free the vehicle if stuck
in snow or mud, by temporarily stopping operation of the ESC, to maintain wheel
torque.
To turn ESC off wh ...
VSM operation
VSM ON condition
The VSM operates when:
The Electronic Stability Control (ESC) is on.
Vehicle speed is approximately above 15 km/h (9 mph) on curve roads.
Vehicle speed is approximately above 20 k ...
Other information:
Hyundai Kona (OS) 2018-2025 Service Manual: Turn Signal Lamp Repair procedures
Removal
Front turn signal lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the Daytime Running Light (DRL).
(Refer to Lighting system - "Daytime Running Light (DRL)" )
...
Hyundai Kona (OS) 2018-2025 Service Manual: Brake Pad Repair procedures
Replacement
Front Brake Pad
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
...
