Hyundai Kona: Exterior lights / Battery saver function
The purpose of this feature is to prevent the battery from being discharged. The system automatically turns off the position lamp when the driver turns the engine off and opens the driver-side door.
With this feature, the position lamps will turn off automatically if the driver parks on the side of road at night. If necessary, to keep the lamps on when the engine is turned off, perform the following:
1) Open the driver-side door.
2) Turn the position lamps OFF and ON again using the light switch on the steering column.
Rear fog lamp
Vehicle with front fog lamp
To turn on the rear fog lamp:
Position the light switch in the position lamp position, turn the light switch
(1) to the front fog lamp position, and then turn the light s ...
Headlamp delay function
If you place the ignition switch to the ACC or OFF position with the headlamps
ON, the headlamps (and/or position lamps) remain on for about 5 minutes. However,
with the engine off if the driver’s ...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Timing Chain Cover & Oil Pump Assembly Repair procedures
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while
...
Hyundai Kona (OS) 2018-2026 Service Manual: Intercooler Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
3.
Remove the engine room under cove ...
