Hyundai Kona: Warning and indicator lights / 4 Wheel Drive (4WD) LOCK Indicator Light
.png)
This indicator light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It illuminates for approximately 3 seconds and then goes off. - When you select 4WD Lock mode by pressing the 4WD LOCK button.
- The 4WD LOCK mode is to increase the drive power when driving on wet pavement, snow covered roads and/or off-road.
NOTICE
Do not use 4WD LOCK mode on dry paved roads or highway, it can cause noise, vibration or damage of 4WD related parts.
LED Headlamp Warning Light
This warning light illuminates:
When you turn the ignition switch or the Engine Start/Stop button to the
ON position.
When there is a malfunction with the LED headlamp.
In this case, we recomme ...
Cruise Indicator Light
This indicator light illuminates:
When the cruise control system is enabled.
...
Other information:
Hyundai Kona (OS) 2018-2026 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CKPS) and Camshaft Position
Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing
by using these signals.
Generally CKPS signal is used to detect the piston's position a ...
Hyundai Kona (OS) 2018-2026 Service Manual: Hood Latch Repair procedures
Replacement
1.
Disconnect the hood lower latch connector (A).
2.
Disconnect the hood latch wiring (A).
3.
Disconnect the coolant hose clip (A).
4.
Loosen t ...
