Hyundai Kona: Rear Door / Rear Door Latch Repair procedures

Replacement

1.	Remove the rear door outside handle. (Refer to Rear Door - "Rear Door Outside Handle")

Loosen the rear door latch mounting screws.

Tightening torque :

6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft)

Loosen the rear outside handel base mounting screw (A) and connector (B).

Tightening torque :

3.9 - 7.8 N.m (0.4 - 0.8 kgf.m, 2.9 - 5.8 lb-ft)

After loosening the mounting nuts, remove the rear door channel (A).

Tightening torque :

3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

5.	Remove the rear door latch (A).

6.	After loosening the rear door outside handle rod (A), remove the rear door outside handle base (B).

To install, reverse removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Replace any damaged clips (or pin-type retainers).

Component Location 1. Rear door latch ...

Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. After loosening ...

Hyundai Kona (OS) 2018-2026 Service Manual: Crankshaft Damper Pulley Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the engineroom under cover. (Refer to Engine and Transmission Assembly - "Engine Room Under Cover") ...

Hyundai Kona (OS) 2018-2026 Service Manual: Transmission Gear Oil Repair procedures
Inspection • Park the vehicle on flat ground and turn off the engine. 1. Uplift the vehicle with lift 2. Remove ...