| Replacement |
| 1. |
Pull down the rear door window glass to the lowest level by pressing
the power window glass switch.
|
| 2. |
After loosening the mounting screws, remove the rear door belt outside
weartherstrip (A) by pulling it upward.
|
| 3. |
To install, reverse removal procedure.
|
Rear Door Latch Repair procedures
Rear Door Belt Inside Weatherstrip Repair proceduresHyundai Kona (OS) 2018-2026 Service Manual: Components and components location
Component Location Index
Engine Room
1. Expansion valve
2. Service port (Low pressure)
3. Service port (High pressure)
4. A/C Pressure transducer (APT)
5. Compressor
6. Discharge hose
7. Suction & Liquid tube assembly
...
Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Troubleshooting
Symptom
Probable cause
Remedy
play in steering
Loose yoke plug
Retighten
Loose steering gear mounting bolts
Retighten
Loose or worn tie rod end
...