Hyundai Kona: Rear Door / Rear Door Belt Inside Weatherstrip Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Belt Inside Weatherstrip Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).

3.
To install, reverse removal procedure.
  
•
When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame.
•
Replace any damaged clips.
Rear Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. After loosening ...

Rear Door Side Weatherstrip Repair procedures
Replacement [Rear door side weatherstrip] 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 21 ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Sunroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim") 3. Disconnect the sunroof motor (A) connector. ...

Hyundai Kona (OS) 2018-2026 Service Manual: Repair procedures
Inspection [System Inspection] 1. Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold. – At Cold Engine [Engine Coolant Temperature < 60°C (140°F)] ...

© 2018-2026 www.hkona.com