Hyundai Kona: Rear Door / Rear Door Side Weatherstrip Repair procedures

Replacement

[Rear door side weatherstrip]

Loosen the rear door checker (B) mounting bolt.

Tightening torque :

21.6 - 32.4 N.m (2.2 - 3.3 kgf.m,15.9 - 23.9 lb-ft)

2.	Detach the clips, remove the rear door side weatherstrip (A).

To install, reverse removal procedure.

•	Replace any damaged clips.

[Rear door body side weatherstrip]

4.	Detach the clips, then remove the rear door body side weatherstrip (A).

5.	To install, reverse the removal procedure.

Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside wea ...

...

Hyundai Kona (OS) 2018-2025 Service Manual: Evaporator Temperature Sensor Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of t ...

Hyundai Kona (OS) 2018-2025 Service Manual: Coolant Repair procedures
Replacement and Air Bleeding • Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the ra ...