Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the installation nuts (A) and then remove the accelerator pedal
module.
|
Installation |
1. |
Install in the reverse order of removal.
|
Hyundai Kona (OS) 2018-2023 Owners Manual: Key ignition switch
Whenever the front door is opened, the ignition switch will illuminate, provided
the ignition switch is not in the ON position. The light will go off immediately
when the ignition switch is turned on or go off after about 30 seconds when the
door is closed. (if equipped)
WARNING
• NEVER turn t ...
Hyundai Kona (OS) 2018-2023 Service Manual: Engine Control Module (ECM) Schematic diagrams
ECM Terminal and Input/Output
signal
ECM Terminal Function
Connector [A]
Pin No
Description
Connected to
1
Ignition coil (Cylinder #4) control output
Ignition coil (Cylinder #4)
...