Hyundai Kona: ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor Description and operation

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor Description and operation

Description
In order to ensure adequate brake power assistance in every situation, the brake booster is equipped with a partial vacuum sensor. The brake booster vacuum pressure sensor is located beside the brake booster.

Battery Sensor Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. Battery negative (-) terminal tightening nut : ...

Brake Booster Vacuum Pressure Sensor Schematic diagrams
Circuit Diagram ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the connection hose (9) of the compressor directly to the tire valve. 3. Plug the compressor power cord into the vehicle power outlet. 4. Adjust the tire inflation pressure to the recomended t ...

Hyundai Kona (OS) 2018-2026 Service Manual: ESP Control Unit Repair procedures
Removal 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Separate the intercooler inlet hose (A) from the turbocharger and then remove the inter cooler inlet pipe (B). [Gasoline 1.6 T-GDI] ...

В© 2018-2026 www.hkona.com