Hyundai Kona: Charging System / DC/DC Converter Description and operation

Due to the considerably more frequent occurrence of starting operations, the electrical load that occurs often leads to voltage dips in the vehicle network.

In order to stabilize the power supply for certain voltage-sensitive electrical components, a DC/DC converter is used in conjunction with the ISG function.

The DC/DC converter supplies the relay with a voltage that also remains constant during the starting operation.

The DC/DC converter is fitted at the behind of the glove box.

Via the test leads for input voltage and the start relay, the electronics decide whether the power is supplied to the output via the bypass or the DC/DC converter.

In the bypass mode, the on-board supply voltage is not fed across the DC/DC converter, but rather is transferred directly to the outputs. In the booster phase, the vehicle voltage is adapted.

Alternator Repair procedures

Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the air compressor connector (A) and th ...

DC/DC Converter Components and components location

Component Location 1. DC/DC converter [450W] 2. DC/DC converter [200W] ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted w ...

Hyundai Kona (OS) 2018-2026 Service Manual: Front Seat Belt Pretensioner Repair procedures
Replacement    • When installing the belt, make sure not to damage the pretensioner. 1. Remove the center pillar upper trim. (Refer to I ...