Hyundai Kona: Auto Lighting Control System / Description and operation

Hyundai Kona (OS) 2018-2026 Service Manual / Body Electrical System / Auto Lighting Control System / Description and operation

Description

It's a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment's illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.

1.	Do not add another device on top of this device.

2.	Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.

3.	Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may very depending on the climate, season, and surrounding environment.

4.	Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.

5.	Error may occur if light block coating that may change interior illumination is applied.

Schematic diagrams

Circuit Diagram ...

Auto Light Sensor Repair procedures

Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sen ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Rear center seatbelt (3-point rear center seat belt)
1.Insert the tongue plate (1) into the buckle (2) until an audible “click" is heard, indicating the latch is locked. Make sure the belt is not twisted. When using the rear center seat belt, the buckle with the “CENTER” mark must be used. WARNING Always have the metal tab inserted into the b ...

Hyundai Kona (OS) 2018-2026 Service Manual: Troubleshooting
Troubleshooting Trouble symptom Probable cause Remedy Displayed the warning lamp "E" (Driving is only possible with 1 / R gear) Not performed DCT learning Perform the DCT manual learning procedu ...