Hyundai Kona: Repair procedures / Front Impact Sensor (FIS) Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Restraint / Repair procedures / Front Impact Sensor (FIS) Repair procedures

Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Loosen the mounting bolt and then remove the front impact sensor after disconnecting the connector (A).

Installation

•	Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.

1.	Install the new front impact sensor.

2.	Connect the front impact sensor connector.

Install the front impact sensor mounting bolt.

Tightening torque :

7.8 - 9.8 N.m ( 0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)

4.	Reconnect the battery negative cable.

After installing the Front Impact Sensor, confirm proper system operation :

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS) Description and operation

Description • The front impact sensors (FIS) are installed on the upper of the side panel in Front End Module (FEM). They are remote sensors that detect ac ...

Side Impact Sensor (SIS) Components and components location

Components 1. Front Pressure Side Impact Sensor (P-SIS) 2. Front Gravity Side Impact Sensor (G-SIS) ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Warning type
If the vehicle detected by the sensors approaches your vehicle, the warning chime will sound, the warning light on the outside rearview mirror will blink and a message will appear on the LCD display. Information The warning chime will turn off when: - The detected vehicle moves out of the sen ...

Hyundai Kona (OS) 2018-2026 Service Manual: Repair procedures
Removal Front seat belt pretensioner (BTP) 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the seat belt lower anchor. (Refer to Body - "Front Seat Belt ...