Hyundai Kona: Restraint / Repair procedures

Component Replacement After Deployment
  
•
Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag(s)
–
Seat belt pretensioner(s)
–
Emergency fastening device(s)
–
Front impact sensors
–
SRS wiring harnesses
–
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag(s)
–
Side impact sensor(s) for the deployed side(s)
–
SRS wiring harnesses
–
Seat belt pretensioner(s)
–
Emergency fastening device(s)
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
–
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.
Description and operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the wa ...

SRSCM Components and components location
Components 1. Front right Pressure Impact Sensor (FIS) 2. Supplemental Restraint System Control Module (SRSCM) 3. Front left Pressure Impact Sensor (FIS) ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Exhaust Gas Temperature Sensor (EGTS) Description and operation
Description Installed in exhaust manifold, the Exhaust Gas Temperature Sensor (EGTS) #1 for WGT senses the temperature of exhaust gas flowing into the WGT. Installed in Gasoline Particulate Filter (GPF) assembly, the Exhaust Gas Temperature Sensor (EGTS) #2 for GPF senses t ...

Hyundai Kona (OS) 2018-2026 Service Manual: Power Door Lock Module Repair procedures
Inspection    • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • ...

© 2018-2026 www.hkona.com