Hyundai Kona: Front Seat / Front Seat Assembly Repair procedures

Replacement

Open the cover and loosen the front seat mounting bolts.

[Front]

Tightening torque :

49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

[Rear]

2.	Disconnect the main connector (A), side airbag connector (B), front seat belt buckle connector (C). [Driver's] [Passenger's]

To install, reverse removal procedure.

The installation procedures of seat mounting bolts

•	Push the seat to the rear end of slides and initially tighten the front mounting bolts.

•	Push the seat to the front end of slides and completely tighten the rear mounting bolts.

•	Send the seat to the rear end again to completely tighten the front mounting bolts.

•	Check the seat for smooth movement.

•	For the non-automatic slide seats, check the seats are fixed at each designated fixing position.

Component Location 1. Front seat headrest 2. Front seat back cover 3. Front seat cushion cover ...

Component Location 1. Front seat shield outer cover ...

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Glass Defogger Printed Heater Repair procedures
Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, mo ...

Hyundai Kona (OS) 2018-2026 Service Manual: Fuel Pressure Sensor (FPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 50 (0. ...