Hyundai Kona: Steering wheel / Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Turn the steering wheel so that the front wheels can face straight ahead.

3.	Remove the drive airbag module. (Refer to Restraint - "Drive Air Bag Module")

4.	Disconnect the steering wheel connector (A).

Remove the steering wheel lock bolt (B) and then separate the steering wheel from the steering column.

Tightening torque :

44.1 - 49.0 N.m (4.5 - 5.0 kgf.m, 32.5 - 36.2 lb-ft)

•	Do not reuse the steering lock bolt.

•	When assembling, match the gear teeth as the below illustration.

Installation

1.	Install in the reverse order of removal.

Disassembly

[Non-Paddle Shift Type]

1.	Loosen the screw and then remove the lower cover (A).

2.	Disconnect the remote control switch connector (A).

3.	Remove the heated steering wheel wiring (B) from the steering wheel after loosening the screw (A).

4.	Loosen the screw (A) and then remove the remote control switch (B).

5.	Remove the steering wheel ornament (A).

[Paddle Shift Type]

1.	Remove the paddle shift switch (A) and then disconnect the connector.

2.	Loosen the screw and then remove the lower cover.

3.	Disconnect the remote control switch connector (A).

4.	Remove the heated steering wheel wiring (B) from the steering wheel after loosening the screw (A).

5.	Loosen the screw (A) and then remove the remote control switch (B).

6.	Remove the steering wheel ornament (A).

Components 1. Drive air bag module (DAB) 2. Ornament 3. Remote control switch 4. Wiring 5. Steering wheel 6. Paddle shift switch 7. Lower cover ...

Compoents Location 1. Heated Steering Wheel Switch ...

Hyundai Kona (OS) 2018-2026 Service Manual: General information
General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work. • The support rod must be inserted into t ...

Hyundai Kona (OS) 2018-2026 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 32.5 (0.33, 4.71) 0.5 284 (2.90, 41.19) 4.5 ...