Hyundai Kona: Seat warmers and air ventilation seats / Front seat warmers

Seat warmers are provided to warm the seats during cold weather.

WARNING

The seat warmers can cause a SERIOUS BURN, even at low temperatures and especially if used for long periods of time.

Passengers must be able to feel if the seat is becoming too warm so they can turn it off, if needed.

People who cannot detect temperature change or pain to the skin should use extreme caution, especially the following types of passengers:

WARNING

NEVER place anything on the seat that insulates against heat when the seat warmer is in operation, such as a blanket or seat cushion. This may cause the seat warmer to overheat, causing a burn or damage to the seat.

NOTICE

To prevent damage to the seat warmers and seats:

[A] : Type A, [B] : Type B

While the engine is running, push either of the switches to warm the driver's seat or front passenger's seat.

During mild weather or under conditions where the operation of the seat warmer is not needed, keep the switches in the OFF position.

Information

With the seat warmer switch in the ON position, the heating system in the seat turns off or on automatically depending on the seat temperature.

Seat warmers and air ventilation seats
...

Front air ventilation seat
The air ventilation seats are provided to cool the front seats by blowing air through small vent holes on the surface of the seat cushions and seatbacks. When the operation of the air ventilation se ...

Other information:

Hyundai Kona (OS) 2018-2021 Owners Manual: Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. 2 / HI – High wiper speed 1 / LO – Low wiper speed O / OFF – Off Push the lever away from you to spray rear washer ...

Hyundai Kona (OS) 2018-2021 Service Manual: Fuel Pressure Sensor (FPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 50 (0. ...

© 2018-2021 www.hkona.com