Hyundai Kona: Windshield Wiper/Washer / Front Washer Motor Repair procedures

Inspection
Front Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
  
•
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively.
3.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
4.
If they are abnormal, replace the washer motor.
[Front & Rear washer]
No
Description
1
Front windshield washer (+)
2
Ground
3
Rear windshield washer (+)

Removal
  
•
When servicing the washer pump, be careful not to damage the washer pump seal.
•
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the right front wheel guard.
(Refer to Body - "Front Wheel Guard")
3.
Remove the engine room under cover
(Refer to Engine Mechanical System - "Engine Room Under Cover")
4.
Remove the washer hose (B) and disconnect the washer motor connector (A).

5.
Remove the reservoir washer inlet (A) after loosening the mounting bolt.

6.
Remove the washer motor (B) after disengaging the fixed hook (A).

7.
Remove the level sensor switch (A).

Installation
1.
Install the washer reservoir.
  
•
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Install the washer motor.
3.
Install the washer hose.
4.
Connect the washer motor connector and level sensor connector.
5.
Install the tire and wheel guide cover.
(Refer to Body - "Front Wheel Guard")
6.
Install the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
7.
Check the washer motor operation.
Front Wiper Motor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary, release the wiper blade fixing clip by pulling ...

Rain Sensor Components and components location
Components and Components Location ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: ETC (Electronic Throttle Control) System Description and operation
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to receive driver input. The ECM ...

Hyundai Kona (OS) 2018-2026 Owners Manual: Resetting the sunroof
The sunroof may need to be reset if the following conditions occur: - The battery is discharged or disconnected or the sunroof fuse has been replaced or disconnected - The sunroof control lever is not operating correctly To reset the sunroof, perform the following steps: 1. Place the ignition switc ...

© 2018-2026 www.hkona.com