Hyundai Kona: Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and operation

Hyundai Kona (OS) 2018-2021 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and operation

Description
The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.Based on the fuel pressure measured by the FPS and the amount of fuel consumed, the fuel pump control module (FPCM) determines whether to activate the low pressure fuel pump.After activating the low pressure fuel pump, the FPS continues to provide the fuel pressure information to the FPCM and the FPCM keeps controlling the fuel flow rate using the feedback information from the FPS.

Fuel Pump Control Module (FPCM) Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") ...

Fuel Pressure Sensor (FPS) Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 50 (0.51, 7.3) 0.3 600 (6.12, 87.0) ...

Other information:

Hyundai Kona (OS) 2018-2021 Service Manual: Exhaust Gas Temperature Sensor (EGTS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the connector of exhaust gas temperature sensors #1/#2. 3. Measure resistance between sensor signal terminal and ground terminal. 4. ...

Hyundai Kona (OS) 2018-2021 Service Manual: Rear Differential Carrier Components and components location
Components Location 1. Rear drive shaft (LH) 2. Coupling assembly 3. Rear differential carrier assembly 4. Rear drive shaft (RH) 5. Propeller shaft assembly ...

© 2018-2021 www.hkona.com