Hyundai Kona: Fuel Delivery System / Fuel Pump Control Module (FPCM) Repair procedures

Hyundai Kona (OS) 2018-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Control Module (FPCM) Repair procedures

Removal

1.	Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")

2.	Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly")

3.	Remove the fuel pump service cover (A).

4.	Disconnect the fuel pump control module connector (A).

5.	Disconnect the fuel pressure sensor connector (B).

6.	Disconnect the fuel feed tube quick-connector (C).

7.	Remove the locking ring (A) by using the special service tool [No.: 09310-B8100].

8.	Remove the fuel pump from the fuel tank.

Fuel Pump Control Module (FPCM) Schematic diagrams

Circuit Diagram Terminal Illustration Terminal Function Pin No Description Connected to 1 ...

Fuel Pressure Sensor (FPS) Description and operation

Description The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.Based on the fuel pressur ...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: AVN Remote Controller Repair procedures
Inspection 1. Check for resistance between terminals in each switch position (LH). [LH : Audio + Hands free] Switch Connector terminal Resistance (±5%) ...

Hyundai Kona (OS) 2018-2025 Service Manual: Front Disc Brake Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 - 127.5 ...